Hitachi CP-X268AWF User Manual
66
Troubleshooting
Phenomena that may be easy to be mistaken for machine defects
WARNING
ŹNever use the projector if abnormal operations such as
smoke, strange odor, excessive sound, damaged casing or elements or cables,
penetration of liquids or foreign matter, etc. should occur. In such cases,
immediately turn off the power switch and then disconnect the power plug from
the power outlet. After making sure that the smoke or odor has stopped, contact
your dealer or service company.
penetration of liquids or foreign matter, etc. should occur. In such cases,
immediately turn off the power switch and then disconnect the power plug from
the power outlet. After making sure that the smoke or odor has stopped, contact
your dealer or service company.
1.
Before requesting repair, please check in accordance
with the following chart. This operation sometimes
with the following chart. This operation sometimes
resolves your problem.
If the situation cannot be corrected,
If the situation cannot be corrected,
2.
The projector’s microprocessor may need to
be reset. Please push the Restart switch by using a cocktail stick or similar
be reset. Please push the Restart switch by using a cocktail stick or similar
and the projector will restart.
3.
Some setting may be wrong. Please use the FACTORY RESET function of the
SERVICE item in the OPTION menu
SERVICE item in the OPTION menu
(
45)
to reset all settings to factory default.
Then, if the problem is not removed after the remedy, please contact your dealer
or service company.
or service company.
Phenomenon
Cases not involving a machine defect
Reference
page
Power does not
come on.
The electrical power cord is not plugged in.
Correctly connect the power cord.
15
The power switch is not set to the on position.
Set the power switch to [ | ] (On).
19
The main power source has been interrupted during
operation such as by a power outage (blackout), etc.
operation such as by a power outage (blackout), etc.
Please turn the power off, and allow the projector to cool
down at least 2 minutes, then turn the power on again.
down at least 2 minutes, then turn the power on again.
19
Either there is no lamp and/or lamp cover, or either
RIWKHVHKDVQRWEHHQSURSHUO\¿[HG
RIWKHVHKDVQRWEHHQSURSHUO\¿[HG
Please turn the power off, and allow the projector to cool down
DWOHDVWPLQXWHV$IWHUWKHSURMHFWRUKDVVXI¿FLHQWO\FRROHG
GRZQSOHDVHPDNHFRQ¿UPDWLRQRIWKHDWWDFKPHQWVWDWHRIWKH
lamp and lamp cover, and then turn the power on again.
DWOHDVWPLQXWHV$IWHUWKHSURMHFWRUKDVVXI¿FLHQWO\FRROHG
GRZQSOHDVHPDNHFRQ¿UPDWLRQRIWKHDWWDFKPHQWVWDWHRIWKH
lamp and lamp cover, and then turn the power on again.
64, 65
Neither sounds
nor pictures are
outputted.
The signal cables are not correctly connected.
Correctly connect the connection cables.
13, 14
Signal source does not correctly work.
Correctly set up the signal source device by referring to the
manual of the source device.
manual of the source device.
–
The input changeover settings are mismatched.
Select the input signal, and correct the settings.
20, 21
C
R
/P
R
C
B
/P
B
AUDIO IN
2
AUDIO IN
1
RGB IN
1
RGB IN
2
SD CARD
AUX I/O
DC 5V
0.5A
LAN
CO
NTR
OL
RGB OUT
AUDIO OUT
USB
VIDEO
S-VIDEO