Infocus IN5552L User Manual
27
Alignment menu
Projection Mode: Allows you to change the orientation of the image for ceiling
mounted, rear-projection and table-top orientations.
Fan Mode: Allows you to manually select the fan tilt position. By default, the
position is horizontal (Normal), but if the projector is installed at an angle, it is
recommended that the fan mode be changed to Up or Down accordingly. Note:
Lamp life will be affected when Up or Down is selected. The fan speed also changes
with each orientation.
Lens Control: Allows you to adjust the lens shift. This is the same as pressing the
Lens Shift button on the keypad or remote.
Lens Memory: Allows you to save the lens shift, zoom and focus settings for a
particular source into one of ten memory locations. Press the Enter button to
access the Lens Memory submenu. Use the Save Memory feature to save up to 10
source-specific lens settings. Use Load Memory to restore a saved setting.
Center Lens: Press the Enter button on the remote or control panel to center
the lens.
Warp: Allows you to adjust keystone, rotation, pincushion/barrel, and corner
positions. This is especially useful when projecting on uneven or rounded surfaces
and when stacking two projectors and overlaying the images.
mounted, rear-projection and table-top orientations.
Fan Mode: Allows you to manually select the fan tilt position. By default, the
position is horizontal (Normal), but if the projector is installed at an angle, it is
recommended that the fan mode be changed to Up or Down accordingly. Note:
Lamp life will be affected when Up or Down is selected. The fan speed also changes
with each orientation.
Lens Control: Allows you to adjust the lens shift. This is the same as pressing the
Lens Shift button on the keypad or remote.
Lens Memory: Allows you to save the lens shift, zoom and focus settings for a
particular source into one of ten memory locations. Press the Enter button to
access the Lens Memory submenu. Use the Save Memory feature to save up to 10
source-specific lens settings. Use Load Memory to restore a saved setting.
Center Lens: Press the Enter button on the remote or control panel to center
the lens.
Warp: Allows you to adjust keystone, rotation, pincushion/barrel, and corner
positions. This is especially useful when projecting on uneven or rounded surfaces
and when stacking two projectors and overlaying the images.
Press the Enter button to access the submenu. To make warp adjustments,
highlight the desired option and press the Enter button. Use the arrow keys to
make adjustments. Select Reset to return to factory default settings.
Blanking: Allows you to adjust the display range (blanking) at the top, bottom, left
and right edges of the input signal.
Edge Blend: When set to On, you can adjust the blend width and black level
uplift. Align Patterns are also available.
highlight the desired option and press the Enter button. Use the arrow keys to
make adjustments. Select Reset to return to factory default settings.
Blanking: Allows you to adjust the display range (blanking) at the top, bottom, left
and right edges of the input signal.
Edge Blend: When set to On, you can adjust the blend width and black level
uplift. Align Patterns are also available.
INPUT
PICTURE
LAMPS
ALIGNMENT
CONTROL
SERVICE
Projection Mode
< Front >
Fan Mode
< Normal >
Lens Control
Enter
Lens Memory
Enter
Center Lens
Execute
Warp
Enter
Blanking
Enter
Edge Blend
Enter
Alignment menu