Infocus IN5555L User Manual

The projector has an Auto Power Off feature that automatically turns the projector 
off if no active sources are detected and no user interaction with the projector is 
performed for 20 minutes. By default, this feature is off.

To turn the projector off, press the Power button on the remote or keypad twice. 
The lamp turns off and the LED blinks orange for 10 seconds while the fans 
continue to run to cool the lamp. When the lamp has cooled, the LED lights red and 
the fans stop. Unplug the power cable and turn off the power switch to completely 
power off the projector.

The Status Indicator LEDs on top of the projector indicates the state of the 
projector and is helpful when troubleshooting.

Power:
Solid red

Blinking green

Solid green

Blinking orange

The projector is plugged in.

The power button has been pressed and the software is 
initializing.

The projector is on and initialized.

The power button has been pressed to turn the projector 
off and the fans are running to cool the projector.

Turn the projector off and wait one minute, then turn the 

projector on again. If the Status LED turns on again, service 

is required. Visit www.infocus.com/support to contact 

service.

Lamp1/Lamp 2:
Flashing Green

Solid Green

Flashing Red

Solid Red

The lamp is warming up.

The lamp is on.

A lamp error occured. Turn the projector off and wait one 

minute, then turn the projector on again. If the lamp light 

turns on again, replace the lamp and reset the lamp timer

 

(page 35).

 Note: the projector may need to be serviced.

The lamp needs to be replaced.

The projector is too hot. Make sure the vents aren’t blocked 

(see page 18). Turn the projector off and wait one minute, 

then turn the projector on again. Contact Technical Support 

if the problem persists. Visit www.infocus.com/support to 

contact service.

The shutter is closed. Press the Shutter button to open the 

shutter.