Infocus IN5555L User Manual
35
1
Turn the projector off and unplug the power cord.
2
Wait 60 minutes to allow the projector to cool thoroughly.
3
Remove the lamp doors by loosening 2 captive screws on each lamp door and
pulling the doors straight off being careful not to damage the ground wires
connecting the doors to the projector. Note: Do not remove the ground wires.
pulling the doors straight off being careful not to damage the ground wires
connecting the doors to the projector. Note: Do not remove the ground wires.
4
Loosen the 3 captive shoulder screws (marked by arrows) that attach the first
lamp module to the projector. Carefully remove the lamp module. Do the same
for the second lamp module. Dispose of the lamps in an environmentally
proper manner in accordance with local disposal laws.
lamp module to the projector. Carefully remove the lamp module. Do the same
for the second lamp module. Dispose of the lamps in an environmentally
proper manner in accordance with local disposal laws.
5
Carefully align and insert the new lamp modules and tighten the screws.
6
Replace the lamp doors and secure the screws.
7
Plug in the power cord, turn on the power switch and press the Power button
to turn the projector back on. Note: Connection to a circuit with a minimum of
20A capacity is recommended.
to turn the projector back on. Note: Connection to a circuit with a minimum of
20A capacity is recommended.
8
To reset the lamp hour timer, use the RS232 commands, LMR (Lamp 1) and LDR
(Lamp 2). See “Control commands” on page 47 for more information.
(Lamp 2). See “Control commands” on page 47 for more information.
Turn off and unplug projector
Wait 60
minutes
minutes
(1)
(2)
(3)
(4)
(5)
(6)
Lamp 2
Lamp 1