Kodak KKA User Manual

Dangerous Voltage

[1] Disconnect the main power.

The older style MECHANISM SLIDE LIFT LEVER has an ECCENTRIC on it to do this adjustment.

[2] Do the removal for the MECHANISM ASSEMBLY.

[3] Place the MECHANISM ASSEMBLY on the MECHANISM RUNNING FIXTURE TL-3000.

[4] Energize the MECHANISM FIXTURE.

[5] Press and hold the SELECT LEVER down to move the SLIDE LIFT LEVER to the highest position.

[6] Measure the height of the SLIDE LIFT LEVER.  Use SLIDE LIFT LEVER GAUGE TL-3001.  The SLIDE LIFT

LEVER should make contact with the low surface of the SLIDE LIFT LEVER GAUGE TL-3001;
the SLIDE LIFT LEVER should not make contact with the high surface of the SLIDE LIFT LEVER GAUGE TL-
3001.

[7] Bend the SLIDE LIFT LEVER until the adjustment is correct.

Make a 5/16 in WRENCH to do this adjustment (see the Tools section).  Connect a DIGITAL VOLT  METER
betweens PINS 1 and 3 (ZERO POSITION SWITCH). The DVM should measure • without a TRAY and 0 W with a
TRAY installed.

A091_0016BA

TL-3001

LEVER GUAGE

SLIDE LIFT

SELECT

A091_0016BCA

(not shown)

LEVER

SLIDE LIFT
LEVER