SMART Technologies 40wi User Manual
>set brightness-15
brightness=55
Video source specification values
You can use the source input field described in Source selection controls on next page in a command
to set an absolute value or adjustment value to a source other than the active source. You can do this
while the selected source is inactive, but the source device must be connected or you will receive an
invalid command response.
>set brightness vga1=65
brightness vga1=65
>set brightness vga1-7
brightness vga1=58
Power state controls
These commands put the projector in and out of Standby mode and request the projector’s current
power state. The projector’s power state determines whether certain commands are available at that
time. These settings are available even when the projector is in Standby mode.
Command
Response
on
powerstate=[field]
off
powerstate=[field]
off now
powerstate=[field]
get powerstate
powerstate=[field]
This table describes the power state commands.
Command
Description
on
Turns on the projector.
off
Starts the shutdown process. A dialog box appears on the projected
image with the message, “Press Power Button to Turn off Projector.”
You must send a second Off command within 10 seconds to put the
projector into Standby mode.
image with the message, “Press Power Button to Turn off Projector.”
You must send a second Off command within 10 seconds to put the
projector into Standby mode.
off now
Shuts down the projector immediately. You can’t delay or cancel this
command.
command.
get powerstate
Indicates the projector’s current power state.
C H A P T E R 8
Connecting your room control system to your interactive projector
63