Yamaha LPX-510 User Manual

Page of 83
51
Appendices
Maintenance
If the airfilter becomes clogged with dust or the message 
"The projector is overheating. Make sure nothing is blocking 
the air vent, and clean or replace the air filter." is displayed, 
clean the air filter.
Turn the projector upside-down and use a vacuum cleaner to 
clean the air filter.
* Do not use water or detergents to clean the air filter.
If the air filter is particularly dirty, remove it and clean it if required.
1
Turn off the power, wait for the cool-
down period to end (takes 
approximately 30 seconds), and then 
disconnect the power cord.
2
Remove the air filter cover.
Push the clasp of the air filter cover with your 
finger and pull it upward.
3
Remove the air filter.
Put your finger under the rib at one side of the air 
filter and lift it up. Use a vacuum cleaner to 
remove any dust from the air filter.
Cleaning the Air Filter
Removing the Air Filter
••••
If the air filter becomes clogged with dust, it can result in overheating which 
may cause operating problems or reduce the operating life of the optical 
parts. It is recommended that you clean the air filter about once every three 
months. If using the projector in a dusty location, the air filter should be 
cleaned more often.
••••
If the air filter replacement message above appears frequently, consult your 
dealer.