A&D AD-4212B-101/102/201/301 User Manual

 

62

This is a programmable unit conversion function. It multiplies the weighing data in grams by an 
arbitrary coefficient set in the function table and displays the result.   

The coefficient must be within the range between the minimum and maximum shown below. If the 
coefficient set is beyond the range, an error is displayed and the balance returns to the coefficient 
setting mode, prompting to enter an appropriate value. A coefficient of 1 was set at the factory. 

Model 

Minimum coefficient 

Maximum coefficient 

AD-4212A-100 10000 
AD-4212A-200/600/1000 

0.000001 

1000 

 

 

1  Press and hold the SAMPLE key until ba5fnc of the function table is displayed, then release the key. 

2  Press the SAMPLE key several times to display    mlt

Cadj

 . 

3  Press the PRINT key. The balance enters the mode to confirm or set the coefficient. 

4  The current coefficient is displayed with the first digit blinking.   

  

When it is not to be changed, press the CAL key and proceed to step 6. 

  

When it is to be changed, press the RE-ZERO key 

and proceed to step 5. 

5  Set the coefficient using the following keys. 

SAMPLE key 

To select a digit to change the 

value. The selected digit blinks. 

RE-ZERO key 

To change the value. 

MODE 

key 

To change the decimal point 

position. 

 

Each time the switch is pressed, 

the decimal point position 
changes as follows: 

 

 

 

PRINT key 

To store the new setting, display 

1

end

1

 and go to step 6. 

CAL key 

To cancel the new setting and go 

to step 6. 

6 The balance displays  Unit . Press the PRINT key to enter the unit selection mode. Select the 

programmable-unit (        ) as described in “5-2 Changing the Unit”.   

7  Press the CAL key to exit the programmable-unit function and return to the weighing mode. 

Perform weighing as described in “6-1 Basic Operation (Gram Mode)”. After weighing, the balance 

displays the result (weighing data in grams x coefficient).