Kodak I800 User Manual

 

Manual Feeder / for i800 Series Scanners 

A-61530_EN 
Part No. 8CK187 
January 2006 

 

The Kodak Manual Feeder / for i800 Series Scanners provides a flat work surface to aid in manual feeding. 

This document provides instructions on how to install and use the manual feeder. 

 

Before installing the manual feeder the elevator tray 
must be in the lowest position. 

1.  Select this icon 

 to lower the elevator tray. 

2.  Open the side guides on the scanner to the widest 

position. 

 

3.  Place the manual feeder on top of the elevator tray 

using the slots in the manual feeder to align with the 
side guides. Position the manual feeder to the fully 
seated position.  

 

Attaching the manual feeder side guides 
After installing the manual feeder, attach the side 
guides that are packed with the manual feeder.  

The manual feeder has two locations for the side 
guides. Depending on the size of the documents you 
are scanning:  

 

use the holes closest to the center of the manual 
feeder if you are scanning documents smaller 
than 22.23 cm (8.75 in.), or  

 

use the holes farthest away from the center of the 
manual feeder if you are scanning documents 
larger than 22 cm (8.66 in.). 

4.  Align the holes on the manual feeder with the pegs 

on the left side guide as shown. 

 

5.  Repeat step 4 for the right side guide. 

6.  Adjust the side guides to the desired position by 

sliding them in or out to accommodate the size of the 
documents you are scanning.