Star Micronics 4000 User Manual

This printer will start automatically once the jam has been cleared.  In most cases, the
printer will continue printing the rest of your document.

The printer driver software cannot access the printer.  This error could be caused by one
of the following.

1. The printer is Off

2. The printer's parallel

cable is not plugged in
properly.

3. A problem exists within

the cable connection or the
parallel cable is not good.

You need to verify if the printer is turned ON and that the left printer status lamp (Green
LED) is lit or flashing.  Check that the parallel cable is properly connected to the printer
and the computer.

This message indicates that the printer is currently printing your document.

This message indicates a possible problem with the printer's Nonvolatile RAM settings.
Turn the printer off, then on again.  If the problem does not clear, reinstall the WinType
driver.  If after reinstalling the WinType driver, the problem persists, contact your dealer
or Customer Support.

This message indicates a possible problem with the printer's fuser assembly.  Turn the
printer off, then on again.  If the problem persists, contact your dealer or Customer Sup-
port.

This message indicates a possible problem with the printer's scanner assembly.  Turn the
printer off, then on again.  If you see this message persistently, then something is wrong
with the printer's engine.  Call your dealer or Customer Support.

This message indicates that the toner cartridge has not been installed or is not installed
properly.  Open the printer's front cover, install or reinstall the toner cartridge and close
the cover.