Toshiba B-EX4T1 User Manual
2. PRINTER SETUP
ENGLISH VERSION EO1-33089
2.3 Loading Supplies
E2- 5
2.3.1 Loading the Media
The following procedure shows the steps to properly load the media into
the printer so that it feeds straight and true through the printer.
The printer prints both labels and tags.
1. Turn off the power and open the Top Cover.
2. Turn the Head Lever to FREE position, then release the Ribbon Shaft
the printer so that it feeds straight and true through the printer.
The printer prints both labels and tags.
1. Turn off the power and open the Top Cover.
2. Turn the Head Lever to FREE position, then release the Ribbon Shaft
Holder Plate.
3. Open the Print Head Block.
4. Turn the Locking Ring counterclockwise and remove the Supply
Holder from the Supply Shaft.
5. Put the media on the Supply Shaft.
6. Pass the media around the Guide Shaft, then pull the media towards
the front of the printer.
Locking Ring
Supply Holder
Supply Shaft
NOTES:
1. When the Head Lever is
turned to
FREE
position, the
Print Head is raised.
2. To enable printing the Head
Lever must be set to the
LABEL / TAG
position.
(This ensures that the Print
Head is closed.)
Head is closed.)
There are two head pressure
levels in the
LABEL / TAG
position. Set the Head Lever
depending on the media type:
depending on the media type:
Position
LABEL: Labels
Position
TAG : Tags
However, proper position
may differ depending on
media. For details, refer to
your TOSHIBA TEC
authorised service
representative.
media. For details, refer to
your TOSHIBA TEC
authorised service
representative.
3. Do not turn the Locking Ring
counter-clockwise too far or it
may come off the Supply
Holder.
may come off the Supply
Holder.
Top Cover
Print Head Block
Head
Lever
Ribbon Shaft Holder Plate
TAG
LABEL
FREE