Toshiba B-EX4T1 User Manual
2. PRINTER SETUP
ENGLISH VERSION EO1-33089
2.9 Position and Print Tone Fine Adjustment
E2-60
2.9 Position and Print
Tone Fine
Adjustment
Adjustment
2.9.1 Fine Adjustment
This section describes how to fine adjust a print start position, cut/strip
position, reverse feed amount, print tone, and ribbon motor torque.
When a fine adjustment is required, follow the procedure below.
Contents of the Fine Adjustment Menu
Menu Parameter
FEED ADJ.
Adjusts the feed amount to the
print start position
print start position
Adjust set
CUT ADJ.
Adjusts the cut or strip position.
BACK ADJ.
Adjusts the reverse feed amount.
X ADJUST
Adjusts the print position in X
coordinate (horizontal direction)
coordinate (horizontal direction)
TONE ADJ. (TRANS.)
Adjusts the print tone for thermal
transfer printing.
transfer printing.
TONE ADJ. (DIRECT)
Adjusts the print tone for direct
thermal printing.
thermal printing.
RBN ADJ. <FW>
Adjusts the ribbon take-up motor
drive voltage.
drive voltage.
RBN ADJ. <BK>
Adjusts the ribbon feed motor
drive voltage.
drive voltage.
THRESHOLD <REFL.>
Sets a fine adjustment value for the
threshold for the reflective sensor.
threshold for the reflective sensor.
THRESHOLD <TRANS.>
Sets a fine adjustment value for the
threshold for the transmissive
sensor.
threshold for the transmissive
sensor.
NOTE:
The printer driver’s properties screen also has Parameter Fine Adjustment
menu.
menu.
ONLINE Mode
User System Mode
Power ON
[PAUSE]
PAUSE state
Hold down [RESTART]
Power OFF
Hold down [MODE]
•
Reset
•
Parameter setting (
⇒Section 2.6.2)
•
Fine adjustment (
⇒Section 2.9)
•
LAN/WLAN (
⇒Section 2.6.3)
•
BASIC (
⇒Section 2.6.4)
•
Z-MODE (
⇒Section 2.6.5)
•
AUTO calibration (
⇒Section 2.6.6)
•
Dump mode (
⇒Section 2.6.7)
•
Log (
⇒Section 2.6.8)
USER SYSTEM MODE
<1>RESET
<2>PARAMETER SET
<2>PARAMETER SET
<3>ADJUST SET
<4>LAN/WLAN