Toshiba B-SX4T-GS20-QM-R User Manual
- 181 -
f
Transmissive sensor (when using preprinted labels):
Feeding takes place according to the parameter designated by the Label Size
Set Command. However, the label-to-label gap is automatically sensed by
the transmissive sensor and the stop position is finely adjusted according to
the value set by the threshold set operation (key operation).
Set Command. However, the label-to-label gap is automatically sensed by
the transmissive sensor and the stop position is finely adjusted according to
the value set by the threshold set operation (key operation).
g
Reflective sensor (when using a manual threshold value)
Feeding takes place according to the parameters designated by the Label
Size Set Command. However, the black mark provided on the back of the
tag paper is automatically sensed by the reflective sensor and the paper
position is finely adjusted for every piece, according to the value set by the
threshold set operation (key operation).
Size Set Command. However, the black mark provided on the back of the
tag paper is automatically sensed by the reflective sensor and the paper
position is finely adjusted for every piece, according to the value set by the
threshold set operation (key operation).
(2)
Cut/non-cut
This option is valid in the batch feed mode only. (Non-cut is selected in the strip
mode.) If no subsequent command is received from the PC for 1 second when
the automatic forward feed is set to ON, the printer automatically performs an
approximately 13.7-mm forward feed.
mode.) If no subsequent command is received from the PC for 1 second when
the automatic forward feed is set to ON, the printer automatically performs an
approximately 13.7-mm forward feed.
When the Feed Command is received in the forward feed standby state, the
printer performs a reverse feed to the original position.
printer performs a reverse feed to the original position.
* For notes, refer to the section regarding the Issue Command.
For cutting the label having label pitch of 38 mm or less by the swing cutter,
refer to the section regarding the Position Fine Adjust Command.
(3)
Feed
mode
[C: Batch (Non-cut)]
[C: Batch (Cut)]
• “Automatic forward feed standby” is set to OFF in the system mode.
• The swing cutter is used.
Head position
(1) Place
paper.
(2) Completes a feed.
(Completes feeding to the top of paper and stops.)
(2) Completes a feed.
(Completes feeding to the top of paper.)
Head position
Cut position
(1) Place
paper.
(3) Feeds to the cut position.
(4) Cuts unnecessary paper.
(5) Feeds back to the home position.