Toshiba B-SX4T-GS20-QM-R User Manual

 

- 264 -

(5) 

Head Open Error 

 

c

  If the head open sensor detects the open state in 5 mm continuously, an error will result.     

 

d

 If the head open sensor detects the open state when an issue, a feed, or an ejection is 

attempted in a printer stop state, an error will result. 

 

e

  If the head-up sensor detects the head-up state in 5 mm continuously, an error will result. 

 

f

 If the head-up sensor detects the head-up state when an issue, a feed, or an ejection is 

attempted in a printer stop state, an error will result. 

 

  However, the feeding by the [FEED] key on the printer and the issuing and feeding by the 

expansion I/O are not included. 

(6)  Thermal Head Error 

 

c

  A broken dot error has occurred in the thermal head.     

 

d

  An error has occurred in the thermal head driver. 

(7)  Thermal Head Excessive Temperature 

 

c

  When the open-air temperature detection thermistor detects an excessively high temperature 

(61 °C or more), an error will result. 

 

d

 When the thermal head temperature detection thermistor detects an excessively high 

temperature (80 °C or more), an error will result. 

 

e

  When the heat sink sensor detects an excessively high temperature (91 °C or more), an error 

will result. 

(8) Ribbon 

Error 

 

c

  When the ribbon rewind motor sensor and ribbon back tension motor sensor do not perform 

detection if twice the prescribed time has passed, an error will result. 

 

  •  An abnormal condition has occurred in the sensor for determining the torque for the ribbon 

motor.   

 

  •  A ribbon jam has occurred.     

 

  •  The ribbon has run out.     

 

  •  The ribbon has not been installed.     

(9) Rewinder 

Overflow 

 

c

  If the rewinder overflow sensor detects the overflow state in 5 mm continuously when the strip 

function or the built-in rewinder is specified, an error will result.     

 

d

 If the overflow sensor detects an overflow state when an issue, a feed, or an ejection is 

attempted in a printer stop state after the strip function or the built-in rewinder is specified, an 
error will result. 

 

* At the moment an error occurs, the printer shows the error message, makes a status response, 

and then stops.  Only the Status Request Command and the Reset Command can be 
processed.  Other commands are not processed.  Restoration using the [RESTART] key is 
possible except in the case of a thermal head excessive temperature error.  (The printer 
resumes printing a label at which the error had occurred.)