Toshiba B-SX4T-GS20-QM-R User Manual
- 32 -
5.2 LABEL ISSUE OPERATION
An example of the label issue operation is described below.
(1) Where the Saved Data Call Command is not used:
NOTES: (1) When placing new paper, the Label Size Set Command and the Feed Command must
always be sent. When using the same paper after the power is turned off and on, the
Label Size Set Command and the Feed Command may be omitted.
Label Size Set Command and the Feed Command may be omitted.
(2) After the power is turned off and on, the Bit Map Font Format Command, the Outline
Font Format Command, and the Bar Code Format Command should be sent as
occasion demands because they are not protected in memory.
occasion demands because they are not protected in memory.
Power ON
Bit Map Font Data Command
<Change data issue>
Yes
Position Fine Adjust Command
Print Density Fine
Adjust Command
Image Buffer Clear Command
Line Format Command
Bit Map Font Format Command
Outline Font Format Command
Bar Code Format Command
[ESC] D: Sets the label size.
[ESC] AX: Adjusts the feed length, cut position, and
back feed length.
[ESC] AY: Adjusts the print density.
[ESC] C: Clears the image buffer.
[ESC] LC: Sets the line format and draws it.
[ESC] PC: Sets the bit map font format.
[ESC] PV: Sets the outline font format.
[ESC] XB: Sets the bar code format.
[ESC] RC: Draws bit map font data.
Feed Command
[ESC] T: Feeds one sheet of paper and aligns it
with the first print position.
Outline Font Data Command
[ESC] RV: Draws outline font data.
Bar Code Data Command
[ESC] RB: Draws bar code data.
Issue Command
[ESC] XS: Issues (prints) the label.
No
<Format change>
Yes
No
<Label change>
Yes
No
Power OFF
Label Size Set Command
Place paper