Toshiba B-SX5T SERIES User Manual
APPENDIX 1 SPECIFICATIONS
ENGLISH VERSION EO1-33036
A1.4 Ribbon
EA1- 5
A1.3.4
Effective Print Area (Cont.)
The figure below shows the effective print area on the media.
A1.4 Ribbon
Please make sure that the ribbon being used is approved by TOSHIBA TEC. The warranty does not apply to any
problem caused by using non-approved ribbons.
For information regarding TOSHIBA TEC approved ribbon, please contact a TOSHIBA TEC service
representative.
Type Spool
type
Width
68 – 134 mm
Recommended width is 41, 50, 68, 102, and 134 mm.
Recommended width is 41, 50, 68, 102, and 134 mm.
Length 600
m
Outside Diameter
φ
90 mm (max.)
The table below shows the correlation between ribbon width and media width (backing paper is not included.)
Ribbon width
Media width
Ribbon width
Media width
41 mm
30 – 36 mm
102 mm
63 – 97 mm
50 mm
36 – 45 mm
134 mm
97 – 140 mm
68 mm
45 – 63 mm
NOTES:
1. Be sure not to print on the 1.5-mm wide area from the media edges (shaded area in the above figure).
Printing this area may cause ribbon wrinkles, resulting in a poor print quality of the guaranteed print area.
2. The centre of media is positioned at the centre of the Print Head.
3. Print quality in the 3-mm area from the print head stop position (including 1-mm non-printable area for print
3. Print quality in the 3-mm area from the print head stop position (including 1-mm non-printable area for print
speed slow down) is not guaranteed.
NOTES:
1. To ensure print quality and print head life use only TOSHIBA TEC specified ribbons.
2. To avoid ribbon wrinkles use a ribbon that is wider than the media by 5 mm or more. However, too much
2. To avoid ribbon wrinkles use a ribbon that is wider than the media by 5 mm or more. However, too much
difference in width between the two may cause wrinkles.
3. When using a 134 mm wide media, be sure to use a 130 mm wide ribbon. Use of other ribbons may cause
ribbon wrinkles.
Start line
Area to be detected.
Area to be detected.
Media feed direction
1.5 mm from the
left edge of media
Media width
(backing paper width is not included.)
Media height
10 – 1500 mm
10 – 1500 mm
1.5 mm from the
right edge of media
right edge of media
1mm
1mm
Guaranteed print area