Toshiba e-STUDIO161 User Manual
BEFORE USING THE MACHINE
15
1
Loading the bypass tray
1
Unfold the bypass tray.
When feeding large
paper such as B4 and A3
(LG and LD), pull out the
bypass tray extension.
paper such as B4 and A3
(LG and LD), pull out the
bypass tray extension.
2
Set the paper guides to the copy
paper width.
paper width.
3
Insert the paper (print face down) all
the way into the bypass tray.
the way into the bypass tray.
To prevent a misfeed,
verify once more that the
paper guides are
adjusted to the width of
the paper.
verify once more that the
paper guides are
adjusted to the width of
the paper.
Important points when inserting paper in the bypass tray
•
Up to 100 sheets of standard copy paper can be set in the bypass tray.
•
Be sure to place A6, A5 or ST size paper or envelopes horizontally as shown in the following diagram (
).
•
When loading envelopes, make sure that they are straight and flat and do not have loosely glued construction
flaps (not the closure flap).
flaps (not the closure flap).
•
Special papers except TOSHIBA recommended transparency film, labels, and envelopes must be fed one sheet at
a time through the bypass tray.
a time through the bypass tray.
•
When adding paper, first remove any paper remaining in the tray, combine it with the paper to be added and then
reload as a single stack. The paper to be added must be the same size and type as the paper already in the tray.
reload as a single stack. The paper to be added must be the same size and type as the paper already in the tray.
•
Do not use paper that is smaller than the original. This may cause smudges or unclean images.
•
Do not use paper that has already been printed on by a laser printer or plain paper fax machine. This may cause
smudges or unclean images.
smudges or unclean images.
If you loaded paper in the bypass tray, press
the [TRAY SELECT] key (
the [TRAY SELECT] key (
) to select
the bypass tray. The bypass tray will not be
selected automatically.
selected automatically.
Note
Available
Not available