Toshiba TRST-56 SERIES User Manual
5. INSTALLATION PROCEDURE
EO1-13016
5.2 Connecting the Drawer
5- 3
1)
Turn the printer power OFF.
2)
Connect the drawer cable to the drawer interface connector in the correct orientation.
3)
Secure the ground wire of the drawer to the ground terminal on the rear of the printer.
NOTE: A TOSHIBA TEC drawer can be connected to the drawer interface connector. Regarding the
connectable drawers, please contact your authorised TOSHIBA TEC representative.
When you use this printer for the first time or when the receipt paper has been used up, load a receipt
roll in the following procedures while the printer power is set to ON.
A thermal printer prints thermal receipt paper by applying heat to the paper to react with the chemicals
on the paper surface. A red line which appears on the reverse side of the receipt paper indicates that
the paper is almost used up.
roll in the following procedures while the printer power is set to ON.
A thermal printer prints thermal receipt paper by applying heat to the paper to react with the chemicals
on the paper surface. A red line which appears on the reverse side of the receipt paper indicates that
the paper is almost used up.
CAUTION!
The drawer interface connector is exclusively for connecting a drawer. Do not connect a phone
line or any other cables than the specified drawer cable. Doing so may cause a failure of the
phone line and the printer.
line or any other cables than the specified drawer cable. Doing so may cause a failure of the
phone line and the printer.
Drawer Interface Connector
Drawer Cable
Ground Wire
WARNING!
The print head becomes very hot while printing. Never touch the print head to avoid getting
burned.
burned.
CAUTION!
1. Use only TOSHIBA TEC specified paper. Use of non-specified paper may shorten the print
head life resulting in problems with print quality, cause a paper feed failure, or shorten the
cutter life.
cutter life.
2. Do not subject the thermal receipt roll to water, oil, or heat source as this will darken the paper.
3. Load the receipt roll in the correct orientation. Failure to do this may cause a paper jam error.
4. Care must be taken not to damage the print head and platen when the printer cover is opened
3. Load the receipt roll in the correct orientation. Failure to do this may cause a paper jam error.
4. Care must be taken not to damage the print head and platen when the printer cover is opened
as this may cause a poor print or a printer failure.
5. Do not open the printer cover while the printer is printing.
6. Do not hold the receipt while the printer is printing. Doing so may cause a paper jam.
7. When closing the printer cover, do not press it down too hard.
8. Do not put anything on the printer cover or push the cover too strongly. Doing so may cause a
6. Do not hold the receipt while the printer is printing. Doing so may cause a paper jam.
7. When closing the printer cover, do not press it down too hard.
8. Do not put anything on the printer cover or push the cover too strongly. Doing so may cause a
print failure.
Ground Terminal