Xerox FS-C8008DN User Manual
3.5 Changing the Interface Parameters
3-39
3.5.4
Resolving IP Address
To connect the printer to the network using TCP/IP protocol, you must set the IP address on
the printer. The IP address must be unique to the printer and should be obtained from your
network administrator.
the printer. The IP address must be unique to the printer and should be obtained from your
network administrator.
1
11
1
Activate TCP/IP protocol in the manner described above.
2
22
2
Enter the submenu by pressing the Z
key. Each time you press the U or V key, the
selection changes as shown below.
3
33
3
When >>IP Address is displayed, press the ENTER key. A blinking cursor (_)
appears at the last digit.
appears at the last digit.
4
44
4
Press the U or V key to increase or decrease, respectively, the value at the blinking
cursor. Use the Z and Y keys to move the cursor right and left.
cursor. Use the Z and Y keys to move the cursor right and left.
5
55
5
When the IP address is entered, press the ENTER key.
6
66
6
Press the U or V key to move to Subnet Mask. Perform the same procedure to
complete entering the subnet mask address.
complete entering the subnet mask address.
7
77
7
Then, press the U or V key to move to Gateway. Perform the same procedure to
complete entering the subnet mask address.
complete entering the subnet mask address.
8
88
8
Press the MENU key. The display returns to Ready. You can print a network status
page to confirm that the IP address, subnet mask address, and the gateway address
have been properly set. To print a network status page, see
page to confirm that the IP address, subnet mask address, and the gateway address
have been properly set. To print a network status page, see
which follows.
>TCP/IP >
On
>>DHCP
Off
>>IP Address
000.000.000.000
>>Subnet Mask
000.000.000.000
>>Gateway
000.000.000.000
>>IP Address
000.000.000.000