Xerox DocuColor 40CP User Manual
36
Installing User Software on a Windows Computer
Use the table below as a guide when installing Downloader and Print Calibrator. For
specific instructions, read the information in each dialog box.
specific instructions, read the information in each dialog box.
Using the software for the first time
Before you can use the newly installed software, you must properly configure the
connection to the DocuColor 40 CP.
connection to the DocuColor 40 CP.
Configuring the connection to the server
The first time you use one of the utilities, you are prompted to configure the
connection to the DocuColor 40 CP.The same configuration is used for Downloader
and Print Calibrator, so any change in the configuration affects both of these.
connection to the DocuColor 40 CP.The same configuration is used for Downloader
and Print Calibrator, so any change in the configuration affects both of these.
B
EFORE
YOU
BEGIN
:
•
Print the Configuration page from the Control Panel and note the IP Address of the
DocuColor 40 CP.
DocuColor 40 CP.
You can also set up a Domain Name Server (DNS) for the IP address of the
DocuColor 40 CP in the printcap file and use that name. See your Windows system
documentation for information.
DocuColor 40 CP in the printcap file and use that name. See your Windows system
documentation for information.
Name of dialog box:
Action:
When finished:
Welcome
Read the Setup program
introduction.
introduction.
Click Next.
Choose Destination Location
Specify a hard disk location for the
installed utility software.
installed utility software.
Click Next.
Select Program Folder
Specify a folder name for the utility
software located in the Programs
menu.
software located in the Programs
menu.
Click Next.
Start Copying Files
Verify the information in the
Current Settings area.
Current Settings area.
Click Next.
Information
Acknowledge that the software
installation is complete.
installation is complete.
Click OK.