Xerox EX7750 User Manual

The EX7750 ships with system software preinstalled on the HDD (hard disk drive), so 
you do not need to install system software to begin using the EX7750. A backup copy 
of the system software also resides on a separate partition on the HDD. If you need to 
reinstall the current version of system software in the future (for example, to restore the 
EX7750 to its factory default configuration), you can do so either by restoring the 
backup copy or by using the system software CDs included in the media pack. Both 
methods achieve the same result. Restoring the backup copy of the system software 
requires the Restore/Update Server Software CD and CD 3. Installing system software 
from the system software CDs requires CD 1, CD 2, and CD 3.

This section describes how to restore a backup of the system software using the 
Restore/Update Server Software CD (see 

) and how to install system software 

from the system software CDs (see 

).

Keep in mind the following when installing system software:

•

—The list of jobs in the Job Log and any jobs in the queues are deleted. 

•

—All fonts on the HDD are deleted when you install or restore system 

software. 

•

—Make sure to print a Configuration page before installing any 

system software (see 

 for instructions). The Setup configuration will be lost 

when you install software.

•

––If Acrobat and Command WorkStation 

software are installed on the HDD, they will be deleted when you install system 
software. After installing system software, you must reinstall Acrobat and Command 
WorkStation. 

•

––Custom simulations, custom outputs saved on the HDD, 

calibration data, and variable data documents are deleted when you install system 
software. 

•

—When upgrading the system software, make sure the latest user 

software is installed onto all computers that print to the EX7750. Using 
incompatible versions of the system and user software may result in system 
problems.