Xerox Phaser 3260DNI User Manual

Page of 174
Basic Regulations
Xerox® Phaser® 3052/3260
User Guide
169
European Union
CAUTION:
This is a Class A product. In a domestic environment, this product can cause 
radio interference in which case the user could be required to take adequate measures.
The CE mark applied to this device symbolizes Xerox’s declaration of conformity with the 
following applicable Directives of the European Union as of the dates indicated:
December 12, 2006: Low Voltage Directive 2006/95/EC
December 15, 2004: Electromagnetic Compatibility Directive 2004/108/EC
March 9, 1999: Radio & Telecommunications Terminal Equipment Directive 1999/5/EC
This printer, if used properly in accordance with the user's instructions, is not dangerous for the 
consumer or for the environment.
To ensure compliance with European Union regulations, use shielded interface cables.
A signed copy of the Declaration of Conformity for this device can be obtained from Xerox.
European Union Lot 4 Imaging Equipment Agreement Environmental 
Information
Environmental Information Providing Environmental Solutions and Reducing Cost
Introduction
The following information has been developed to assist users and has been issued in relation to the 
European Union (EU) Energy Related Products Directive, specifically the Lot 4 study on Imaging 
Equipment. This requires manufacturers to improve environmental performance of in scope products 
and supports the EU action plan on energy efficiency.
In scope products are Household and Office equipment that meet the following criteria.
Standard monochrome format products with a maximum speed less than 66 A4 images per 
minute
Standard color format products with a maximum speed less than 51 A4 images per minute
Environmental Benefits of Duplex Printing
Most Xerox products have duplex printing, also known as 2-sided printing, capability. This enables you 
to print on both sides of the paper automatically, and therefore helps to reduce the use of valuable 
resources by reducing your paper consumption. The Lot 4 Imaging Equipment agreement requires that 
on models greater than or equal to 40 ppm color or greater than or equal to 45 ppm monochrome the 
duplex function has been auto enabled, during the setup and driver installation. Some Xerox models 
below these speed bands may also be enabled with 2-sided printing settings defaulted on at the time 
of install. Continuing to use the duplex function will reduce the environmental impact of your work. 
However, should you require simplex/1-sided printing, you may change the print settings in the printer 
driver.