Xerox Phaser 3120 User Manual

The toner in a printer cartridge contains a chemical material, which might harm human body if it is swallowed.
Please keep children out of the toner cartridge.

It is possible to get electric shock or burn by fire if you don't fallow the instructions of the manual.

(1) Use exact voltage. Please do use an exact voltage and wall socket. If not, a fire or an electric leakage can

be caused.

(2) Use authorized power code. Do use the power code supplied with PRINTER. A fire can be occurred when

over current flows in the power code.

(3) Do not insert many codes in an outlet. If do, a fire can be occurred due to flow over current in an outlet.

(4) Do not put water or extraneous matter in the PRINTER. Please do not put water, other liquid, pin, clip, etc.

It can cause a fire, electric shock, or malfunction. If it is happened, turn off the power and remove the

power plug from outlet immediately.

(5) Do not touch the power plug with wet hand. When servicing, do remove the power plug from outlet. And

do not insert or take off it with wet hand. Electric shock can be occurred.

(6) Caution when inserting or taking off the power plug. The power plug has to be inserted completely. If not,

a fire can be caused due to poor contact. When taking off the power plug, do grip the plug and take it off.

If grip the line and pull over, it could be damaged. A fire or electric shock could cause.

(7) Management of power code. Do not bend, twist, or bind it and place other materials on it. Also, do not fix

it with staples. If the power code gets damage, a fire or electric shock can be caused. A damaged power

code must be replaced immediately. Do not repair the damaged part and reuse it. A repaired part with plas-

tic tape can be occurred a fire or electric shock. Do not spread chemicals on the power code. Do not

spread insecticide on the power code. A fire or electric shock can be occurred due to thinner(weak) cover

of the power code.

(8) Check whether the power outlet and the power plug are damaged, pressed, chopped, or blazing fire or

not. When such inferiorities are found, repair it immediately. Do not make it pressed or chopped when

moving the machine.

(9) Caution when thundering, and being flash of lightening. It causes a fire or electric shock. Take the power

plug off when thundering. Do not touch cable and device when thundering and being flash of lightening.

(10) Do avoid the place where is moisture or has dust. Do not install the printer in where have lots of dust or

around humidifier. A fire can be occurred. A plug part need to clean well with dried fabric to remove dust.

If water drops are dripped on the place covered with dust, a fire can be occurred.

(11) Avoid direct sunlight. Do not install the printer near to window where directly contacts to the sunlight. If

the machine contacts sunlight long time, the machine cannot work properly because inner temperature

of the machine is getting higher. A fire can be caused. 

(12) Turn off the power and take off the plug when a smoke, strange smell, or sound from the machine. If you

keep using it, a fire can be occurred.

(13) Do not insert steel or metal piece inside/outside of the machine. Do not put steel or metal piece into a

ventilator. An electric shock could be happened.