Xerox t 180 User Manual
SYSGEN AND SYSGEN-RELATED PROCEDURES
4-32
XEROX DOCUPRINT 180 LPS SYSTEM GENERATION GUIDE
Steps for loading incremental patches
Table 4-7 lists the steps used for loading incremental patches.
Table 4-7.
Steps for loading incremental patches
Step
Action
System response
1.
Load the incremental tape on the
selected peripheral device. The system
should be at logon level 3 or higher.
selected peripheral device. The system
should be at logon level 3 or higher.
OS1000 Ready for Commands hh:mm:ss
2.
Enter COP TAP ALL and press
<ENTER>
<ENTER>
Creating or replacing of files takes place followed by:
**_end of tape read
OS1000 Ready for Commands hh:mm:ss
3.
Enter @xxxx and press <ENTER>
The patches are applied, and the system displays:
PCH (patch name)
** Processing the file . . .**
*** START of (version) SST Incremental
Patches ****
Patches ****
**** END of (version) SST Incremental
Patches********
Patches********
DID THE PATCHES APPLY WITHOUT ANY ERRORS? (Y/N)
4.
Enter Y or N. Answering Y indicates that
the patches were loaded successfully.
the patches were loaded successfully.
If you answer N, you may need to
complete the procedure again.
complete the procedure again.
The system deletes the files applied by the incremental tape
and displays:
and displays:
SYSTEM WILL ROLLOVER IN 1 SEC
The system initializes and displays:
OS1000 - Ready for Commands hh:mm:ss