Xerox 230ST Leaflet

®

 

Connect the DC220/230 to your network 
outlet or cable.

Enter System Administration Setups:

Press the [Access] button on the 
Control Panel.

Enter the System Administrator 

password by typing

(# key and 22222) on the keypad and 
pressing [Enter] on the screen.

Note: #22222 is the factory default 
password and may be changed by 
your Xerox service representative to 
suit your needs.

On the screen display, press [Print 
Setups].

Press [Network Setups].

Note: If TCP/IP has been installed, go to
step 4.  If TCP/IP has not been installed, 
continue with step 3.

Access the TCP/IP Network Setups 
screens:

Press [TCP/IP].

: Press [IP Address], 

then press [Edit] and use the key-
board on the display screen to enter 
the static IP address for the DC220/
230.  This number is assigned by the 
System Administrator 

: Press [RARP], 

then press [Enabled].

Press [Save].

Press [Gateway Address], then press 
[Edit] and use the keyboard on the 
display screen to enter the Gateway 
address of your network.

Press [Save].

Press [Subnet Mask], then press 
[Edit] and use the keyboard on the 
display screen to enter the Subnet 
Mask for your network (default is 
255.255.255.0).

Press [Save].

To install the DC220/230 into a DHCP environ-
ment, exclude the addresses assigned to the 
DC220/230 at the DHCP server.

Record the following information for use during 
setup at the DC220/230:

TCP/IP Address:_________________________

Gateway Address:_______________________

Subnet Mask:_________________________

Broadcast Address:______________________

Host Name:_____________________________

Host Name:_____________________________

Printer Name:___________________________

Workgroup:_____________________________

For assistance, contact your local Xerox Customer Support Center:
USA: 1-800-821-2797      Canada: 1-800-939-3769