Xerox 3435DN User Manual

10.1   

<Installing accessories>

Your printer is a full-featured laser printer that has been optimized to 
meet most of your printing needs. Recognizing that each user may have 
different requirements, however, Xerox makes several accessories 
available to enhance the printer’s capabilities.

This chapter includes:
•

Never remove the control board cover while the power is being supplied.

To avoid the possibility of an electrical shock, always disconnect the 
power cord when installing or removing ANY internal or external 
accessories.

The control board and internal accessories (network interface card and 
memory DIMM) are sensitive to static electricity. Before installing or 
removing an internal accessories, discharge static electricity from your 
body by touching something metal, such as the metal back plate on any 
device plugged into a grounded power source. If you walk round before 
finishing installation, discharge any static electricity once again.

Your printer has a dual in-line memory module (DIMM) slot. Use this 
DIMM slot to install additional memory.

Phaser 3435/DN has 64 MB of memory which can be expanded to 
320 MB. 

For order information for optional memory DIMM’s, see page 7.1.

Turn the printer power off and unplug all cables from the printer.

Grasp the control board cover and slide toward you to open it.

Completely open the latch on each side of the DIMM slot.

Take out a new memory DIMM from the plastic bag.

control board cover

latch