Xerox 4500 ps eth User Manual
Installation
Xerox 4500 PS ETH, Inst. & Operator's Guide
Xerox 4500 PS ETH, Inst. & Operator's Guide
15
2. Installation of Xerox 4500 PS ETH
When unpacking the unit, record the universal MAC address on the
label attached to the rear panel of the unit.
label attached to the rear panel of the unit.
Installation, configuration and changes to the mainframe and LAN of
the Xerox 4500 PS ETH must only be carried out by a person with
authority and knowledge of the relevant environment.
the Xerox 4500 PS ETH must only be carried out by a person with
authority and knowledge of the relevant environment.
CAUTION
The interface can be damaged by static discharge. To prevent this
damage, the interface comes wrapped in an antistatic bag.
damage, the interface comes wrapped in an antistatic bag.
When you remove the interface from the bag and when you install it, hold
the interface by the edges only. Do not touch the components or
connections.
the interface by the edges only. Do not touch the components or
connections.
Do not throw away the antistatic bag. If the interface is removed from the
printer later, it should be kept in the antistatic bag.
printer later, it should be kept in the antistatic bag.
2.1 Pre-Installation task
Prior to installing the Xerox 4500 PS ETH, you should check that
language setting (EU or US language) is correct.
language setting (EU or US language) is correct.
Remaining switches are to be operated by support staff only.
Language setting is performed on the Dip switch bank. The DIP switch
bank sits on the interface
bank sits on the interface
2.1.1 EU - US language settings
Dip switch number 2 is used for language setting.
You can select between EU and US language settings.
Should you need to change language setting, set dip switch number 2
as follows:
as follows:
EU language setting - set the switch to OFF
US language setting - set the switch to ON
US language setting - set the switch to ON
ON
ON
OFF
OFF
1 2 3 4
1 2 3 4