Xerox 4500 ps eth User Manual
Appendix Section
Xerox 4500 PS ETH, Inst. & Operator's Guide
Xerox 4500 PS ETH, Inst. & Operator's Guide
164
Appendix A: Configuration Using Setup File
Appendix A 1: Configuring via parallel port
The default LAN and TCP/IP parameters may be set up via the parallel
port.
port.
If this method is used instead of using the configuration file, then the IP
default (IP address gateway and subnet mask) must be specified in the
configuration file when the PrintServer is set up for the first time.
default (IP address gateway and subnet mask) must be specified in the
configuration file when the PrintServer is set up for the first time.
The configuration file must be sent via the centronics port.
NOTE:
On OS/2 workstations use IBMNULL as printer driver
On DOS or Windows use a Generic /Text printer driver only.
On OS/2 workstations use IBMNULL as printer driver
On DOS or Windows use a Generic /Text printer driver only.
1. Select the file you wish to send to the parallel port.
2. In this file you write the following command sequence at the top of the
file:
&&??##N1,0#<CR>
3. Type:
END
4. To send the file, you write the following at the command prompt.
copy <filename> <lpt1>
where lpt1 is the PC’s centronics port.
5. For the settings to become effective you must either:
- turn the PrintServer off and on
or
- define the PrintServer to boot from the configuration file
or
- define the PrintServer to boot from the configuration file
Type:
BEGIN_CONFIGURATION IDAPS
BEGIN_CONFIGURATION IDAPS
BOOT
You should only modify or change the settings via the bootfile for strictly necessary purposes.
Otherwise, you are recommended to use e.g Psinst32 or Telnet. (see the chapter on
Configuration)
Otherwise, you are recommended to use e.g Psinst32 or Telnet. (see the chapter on
Configuration)