Xerox 840 User Manual

■

Specify the current Directory Services Tree; (the tree where the print 
server will reside).

■

Specify the current Directory Services Context.  (the location in the 
directory services tree where the print server will reside). 

■

Create and select a new queue, or select an existing queue; click Finish. 

After you have entered the configuration information, the Quick Configuration 
Wizard displays the Configured Printer Information dialog box, which reports the 
information you have entered.  

Verify that the information is correct.

■

If the information is correct, click Apply Changes. 

■

If the information is not correct, click Back to return to previous dialog 
boxes and correct the information.  Click Next to return to the 
Configured Printer Information

 dialog box.  Click Apply Changes.

■

To exit the wizard and return to the Main window without making any 
changes, click Cancel.

After you click Apply Changes, the printer resets; the changes take effect 
when the reset is complete.       

After the reset, you are prompted to print a test page.  It is recommended 
that you print a test page to verify a successful installation.

Make sure that the printer is turned on and properly connected to the 
network.  Try a different network drop or port.

Make sure that NetWare is enabled on the printer.  This is reported on the 
printer’s Configuration Page in the NetWare field.  For information on 
enabling and disabling protocols, see Chapter 15, “Disabling Protocols”.   

If your network uses a router, configure the router to not suppress NetWare 
SAP (Service Advertising Protocol) packets or packets of the frame type the 
printer is using.

If you are using bindery emulation, make sure that NDS is disabled.  From 
the PhaserShare Administrator Print Server tab, uncheck the Directory 
Services

 checkbox.