Xerox 4508 User Manual
S e t t i n g U p t h e P r i n t e r
2-12 ❖ D o c u P r i n t 4 5 0 8 U s e r G u i d e
OS/2 Setup
Follow the steps below to install the OS/2 software.
Testing the
Connection
To test the connection, make sure that the READY light is ON
and print a file from a software program you are familiar with.
If the printer does not respond at all when you print the file,
perform the following:
•
Verify that you have installed the 4508 printer driver.
•
Verify that the interface cable is attached securely to both
the printer and the computer.
5
Insert the “Xerox DocuPrint 4508 Software Installation
Diskette” disk in your disk drive.
Diskette” disk in your disk drive.
6
Create a directory in which to place the DOS software
(for example: DOSUTIL) and switch to that directory.
(for example: DOSUTIL) and switch to that directory.
7
Type:
c o p y a : \ d o s u t i l \ * . *
or
c o p y
b : \ d o s u t i l \ * . *
8
Type:
D O S 4 5 0 8
1
Insert the 3.5” diskette labeled “DOS and OS/2 Drivers” into
the disk drive of your computer.
the disk drive of your computer.
2
Double click on the drive icon, then double click on disk
icon, then double click on “INSTALL.TXT” file. Follow
instructions on screen.
icon, then double click on “INSTALL.TXT” file. Follow
instructions on screen.
Note
To install the Remote Control Panel (RCP) option, use the
Windows subsystem of OS/2 and follow the Windows
installation instructions on the previous page.
4508-c02.frm Page 12 Thursday, June 6, 1996 12:04 PM