Xerox 45087638 User Manual

Page of 28
Customer User Addendum
Xerox EX8002 Print Server, Powered by Fiery®, version 1.0
 
for the DocuColor 8002/7002 digital press
Part Number:   45087638 
21 August 2009
Copyright 2009 © Electronics for Imaging, Inc.
This document contains information about Xerox EX8002 Print Server, Powered by Fiery 
software version 1.0. 
N
OTE
This document uses the term “EX8002” to refer to the Xerox EX8002 Print Server, 
Powered by Fiery. The term “digital press” is used to refer to the DocuColor 8002/7002 
digital press.
This document describes the calibration and profiling features of the digital press. The in-line 
spectrophotometer (ILS) on the digital press can be used to calibrate the EX8002 and can also 
be used to create custom output profiles. Calibration and profiling can enhance the quality 
and consistency of the color output.
The calibration and profiling features of the digital press are accessed from ColorWise Pro 
Tools Calibrator. Calibrator lets you:
• Calibrate the EX8002 using an existing calibration set.
• Create a new calibration set and profile for specific print settings and paper.
System 
requirements
To use the calibration and profiling features of the digital press, your system must have the 
following:
• The EX8002 must be connected to the ILS on the digital press via a serial cable. 
The serial cable is installed during the initial setup of your system. If an error occurs 
during color measurement, there might be a problem with the serial cable. Contact your 
authorized service representative.
• EFI Color Profiler Suite must be installed and enabled on the EX8002 (the factory default 
condition). 
If measurement is successful but the data is incorrect, check that Color Profiler Suite is 
installed on the EX8002.