Escort EJ-CR-II User Manual

 

 

© 

Escort Data Logging Systems LTD         DATED: 03/07/07                PAGE 13 

 

•   
 

 
The ChartReader uses standard 57mm wide paper or 2 layer 57mm wide NCR type 
duplicating paper. 
To replace the paper roll perform the  following steps: 
 

 
n 

Open the hinged lid by springing the plastic clip at the rear of the case and lift the lid     

      open. 

o 

Remove the short length of paper remaining in the printing mechanism by: 

       

z using the small FEED button 

 located on the circuit board to the left of the printer    

           mechanism, or 
       

z using the manual wheel (if present), or 

       

z gently pulling the paper through the mechanism by hand in normal   

           direction. 
 
 

Feed through

Approx 6mm

Ribbon Cassette

 

p 

Remove old roll core from the holding fingers and insert the new roll with the paper  

      direction as shown in the diagram above. 

q 

Free the end of the new paper and ensure that the end is cut reasonably straight and   

      square. Trim with scissors if necessary. 

r 

Take the free end of the paper and gently push it over the plastic ramp and into the   

      mouth of the printer  . 

s 

By using the manual feed knob (if present) or the FEED button (with power ON), feed the  

      paper through the mechanism, past the ink ribbon and leave about 6mm (¼ inch) of paper    
      protruding from the top of the mechanism. 

t 

Tighten the ink ribbon in it's cassette by turning the star shaped disc (on the left of the  

      cassette)  2 or 3 turns clockwise. 

u

 Close the case lid making sure the paper feeds through the gap in the lid and secure the  

      lid catch.