Ericsson 7700 User Manual

If you have problems using the optional Auto Take-Up Reel, try these 
solutions:

•

Make sure the AC power cord is plugged into the Auto Take-Up Reel.

•

Make sure you turned the printer off and then on again after installing 
the Auto Take-Up Reel, and that the cable is securely connected to both 
the printer and Auto Take-Up Reel.

•

Make sure there is enough slack in the roll paper as it feeds paper to 
ensure that it interrupts the sensor so the Auto Take-Up Reel can turn. 
See page 204 for details.

•

Make sure the 

Auto

 switch is set for the direction in which you loaded 

the paper to be taken up. See page 207 for details.

•

Make sure you pressed the printer’s l Paper Source button to select 

(Auto Cut Off).

•

If the 

Sensor

 light flashes slowly when you are not printing, the sensor 

may be misaligned or there may be an obstacle in the sensor’s beam. 
Make sure nothing is impeding the sensor’s beam.

•

If the 

Sensor

 light is off, the Auto Take-Up Reel may be turned off or 

the sensor cables may be disconnected. See the installation instructions 
included with the Auto Take-Up Reel.

If you need to uninstall and then reinstall the printer driver software for any 
reason, follow the instructions in the appropriate section below.

1. Select 

System Preferences

, then select 

Print & Fax

.

2. Select your printer, then click the – button.

3. If you want to reinstall your printer software, restart your Macintosh. 

Then follow the instructions on page 51

 

to install the software.