Ericsson 7700 User Manual

When you choose a media type in your Epson printer software, the driver 
automatically determines the best settings for your paper. However, you may 
want to fine-tune how the printer handles various media—especially if you 
use non-Epson paper or a paper not supported by the driver. Use the paper 
configuration settings described below. 

You can create a special configuration, or group of settings, for each paper 
type (up to ten types) and select the desired configuration whenever you 
print on a particular stock. 

To create a configuration for a specific paper type, make sure the paper you 
want to configure is loaded in the printer. Then follow these steps:

1. Press r 

Menu

, then press u or d to select 

PAPER SETUP

.

2. Press r, then press d to select 

CUSTOM PAPER

.

3. Press r, then press d or u to select a paper configuration number (1 to 

10). Press r to save the number setting.

4. Press d or u to select 

PAPER TYPE

, then press r. Press d or u to 

select a media type, then press r. Press

 OK

 to save it. 

5. Press l twice to go back to the previous menu.

6. Press d or u to select 

PLATEN GAP

, then press r. Press the d button 

to select 

NARROW

,

 STANDARD

,

 WIDE

,

 or WIDER

. The 

STANDARD

 setting is recommended for most paper types. Press 

OK

 to 

save the setting, then press l to go back to the previous menu.

7. Press d or u to select 

THICKNESS PATTERN, 

then press r. Press 

OK

 

to print the paper thickness pattern. A pattern similar to the following is 
printed:

Note: Paper 
configurations are needed 
only for non-Epson media.

Note: You can also create 
paper configurations using 
the Epson LFP Remote 
Panel installed from the 
printer software CD.

1

2

3

4

5

6

7

8

9

10

11

12

13

14

15

Smallest gap