Epson T3270 User Manual

Epson SureColor T-Series User’s Guide

This section describes how to remove cut sheets when 
printing is complete. 

Buttons that are used in the following settings

1

Confirm that Paper Eject is displayed in the 
control panel. 

Keeping a hand on the cut sheets to prevent 
them falling from the printer, press the Z 
button. 

2

The paper will be fully ejected from the printer 
and can then be removed by hand. 

This section describes how to load and remove poster 
board from 0.8 to 1.5mm thick. 

The printer can be used with board of the following 
sizes.

A2/A1/B2/B1

*

/B1 landscape

*

/24 × 30 inch/30 × 40 

inch

*

* Not supported by the T3270. 

Poster board requires space both behind and in front of 
the printer. The approximate amount of space required 
is shown below. If the printer is set up near a wall, make 
sure there is enough space at the rear. 

Note:
To remove paper that was loaded but not used, press the 
(

A2

17.4 inches 

(444 mm)

5.3 inches 

(135 mm)

A1

27.2 inches 

(691 mm)

15.0 inches 

(382 mm)

24 

× 30 inch

24.1 inches 

(612 mm)

11.9 inches 

(303 mm)

30 

× 40 inch

34.1 inches 

(866 mm)

21.9 inches 

(557 mm)

c