Epson 1000 User Manual

When this feature is on, the printer determines which interface

receives data and then switches to that interface until the end

of the print job (when no data is received from the selected

interface for the amount of time specified by the Auto interface

wait time). Usually, you should set this feature to on.

When this feature is set to off, the printer receives data only

from the interface specified by the DIP switch on the optional

interface card.

This feature is necessary when the auto interface selection is set

to on. If the data from the computer is not sent within the

specified period, the printer 

 the source of any

new data. Otherwise, the printer receives data only from the

currently selected interface and ignores data from the other

interface. You can set the time to either   seconds or 

seconds.

You can set this feature on to select tear-off mode. See “Using

the tear-off feature” in Chapter 2 for information on tear-off

mode. Use the tear-off feature only with continuous paper.

Do not use the tear-off feature with labels.

You change the printer’s default settings using the control

panel buttons; the control panel lights show your selections.

Follow the steps below to make your changes:

Make sure the printer is turned off and 

 letter, or larger

paper is loaded in the paper feeder.

3-11