Emulex NQGB-NT+ User Manual
2-8 Chapter 2
Reset to Factory Defaults
Before resetting to factory defaults, we recommend that you print out a
configuration page. Using the command described below will reset the
printer server to its factory defaults.
configuration page. Using the command described below will reset the
printer server to its factory defaults.
• The printer server will reset to factory defaults when power is cycled.
• The IP address and subnet mask are reset to NONE (000.000.000.000).
• Non-volatile memory is reset to factory defaults.
• The IP address and subnet mask are reset to NONE (000.000.000.000).
• Non-volatile memory is reset to factory defaults.
To reset to factory defaults:
1) Obtain privileged status.
2) Enter this command:
>
Server>> initialize [server] [delay delay_min]
[default]
[default]
delay
Indicates reintialization will not take place until after a
specified period of time.
specified period of time.
delay_min
Specifies the time before the server is stopped and
the initialization process begins. The default is 1
minute.
the initialization process begins. The default is 1
minute.
default
Resets the server to factory defaults
3) Cycle printer power.