Emulex NQGB-NT+ User Manual

  

Before resetting to factory defaults, we recommend that you print out a 
configuration page.  Two methods can be used to reset the printer server to its 
factory defaults.  

•  Using the status button 

−  The printer server will reset to factory defaults immediately. 
−  IP address and subnet mask are reset to NONE (000.000.000.000). 
−  Non-volatile memory is reset to factory defaults. 

•  Using a software command 

−  The printer server will reset to factory defaults when power is cycled. 
−  IP address and subnet mask are reset to NONE (000.000.000.000). 
−  Non-volatile memory is reset to factory defaults. 

1)  Remove AC power cord from the printer server. 

2)  Depress status button and hold. 

3)  Reconnect AC power cord to printer server, then release status button. 

1)  Obtain privileged status. 

2)  Enter this command: 

> 

Server>> initialize server delay delay_min default 

delay 

Indicates reintialization will not take place until after a 
specified period of time. 

 

Specifies the time before the server is stopped and 
the initialization process begins. The default is 1 
minute. 

 

Resets the server to factory defaults