SATO 10e User Manual
SATO M10e Service Manual
PN: 9001113A
Page 5-1
5
PRINTER CONFIGURATION
DIP SWITCH PANELS
There are two DIP switches (DSW2 and DSW3) located on the front panel under a protective
cover. A third DIP switch is located on the RS232C Serial Adapter card and is used to set the
RS232C transmit/receive parameters.Each switch is an eight section on/off toggle type switch.
The ON position is always oriented upward and consequently, the off is always downward.
Switch settings are read by the printer electronics during the power up sequence and will not
become effective until the power is cycled.
cover. A third DIP switch is located on the RS232C Serial Adapter card and is used to set the
RS232C transmit/receive parameters.Each switch is an eight section on/off toggle type switch.
The ON position is always oriented upward and consequently, the off is always downward.
Switch settings are read by the printer electronics during the power up sequence and will not
become effective until the power is cycled.
RS232 TRANSMIT/RECEIVE SETTING
Data Bit Selection (DSW1-1): Sets the printer to receive either 7 or 8 data bits for each byte
transmitted.
transmitted.
Parity Selection (DSW1-2, DSW1-3): Selects the type of parity used for error detection.
DSW1-1
SETTING
Off
8 Data Bits
On
7 Data Bits
DSW1
ON
OFF
1
2
3
4
5
6
7
8
DSW1-1
DSW1-3
SETTING
Off
Off
No Parity
Off
On
Even
On
Off
Odd
On
On
Not Used
DSW1
ON
OFF
1
2
3
4
5
6
7
8