Ericsson SP4900HDR User Manual

You can convert the spindle to accept roll paper with either a 2-inch or 
3-inch core by using the spindle adapters. Follow these steps to attach the 
adapters for using 3-inch roll paper:

1. Remove the black paper stop from the end of the spindle.

2. Align the arrow marks as shown below and press one of the adapters 

onto the gray paper stop until it locks in place. Press the other adapter 
onto the black paper stop.

To remove the adapters, press on the four tabs.

When you’re not using the auto cut setting, you need to cut the paper 
manually by pressing the 

 button after your print job is finished. You 

can use the button for most types of paper. However, if you’re printing on 
fine art paper, canvas, or other heavy media, you should use a rotary paper 
cutter/trimmer or scissors rather than the built-in cutter. See page 51 for a 
list of media that cannot be used with the built-in cutter.

Follow these steps to cut manually with the built-in cutter:

1. Before you print, press the l Paper Source button and press d to 

highlight 

ROLL PAPER/NO CUT

. Press 

OK

. The 

 roll icon

 

appears 

on the LCD screen.

2. Run your print job.

Note: Roll paper with a 
2-inch core may cause 
paper jams on this printer 
due to severe paper curl. 
If you notice frequent 
paper jams when using 
2-inch core media, switch 
to media with a 3-inch 
core. 

Tab