Roland FJ-50 User Manual
27
2 Basic Operation
Specifying a location in the left-right direction (the direction of carriage movement)
Setting the printing area in the left-right direction (the direction of carriage movement)
* This can be set only at the time of material setup.
Press the [MENU] key and [ ] key to make the
following screen appear on the display.
following screen appear on the display.
1
MENU
PRINT AREA
PRINT AREA
Press the [
] key to make the following screen
appear on the display.
The carriage indicates the present location of the right-
hand edge of the printing area.
The carriage indicates the present location of the right-
hand edge of the printing area.
2
PRINT AREA
MOVE TO R-EDGE
MOVE TO R-EDGE
Right-hand edge of
the printing area
the printing area
Right-hand edge of
the material
the material
Press the [
] key to move the carriage to the present
starting location for printing in the left-right direction.
1
Starting location for
printing in the left and
right direction
printing in the left and
right direction
Right-hand edge of
the material
the material
Use the [
] and [
] keys to line up the new
starting location for printing with the left edge of the
carriage.
carriage.
2
Left edge of the carriage
Press the [BASE POINT] key.
3
The BASE POINT LED lights up
The origin point is set.
To release the starting location that
has been set...
has been set...
• Set a new starting location in a different location.
• Press the [SETUP] key to cancel the setup for the
• Press the [SETUP] key to cancel the setup for the
material (making the SETUP LED go out).
- If the carriage moves away from the standby position when not printing, problems such as drying-out of the printing heads or dot drop-
out during printing may occur. For this reason, about 60 seconds after pressing the [
] key to move the carriage, the carriage returns
to the standby position.
Also, the carriage returns to the standby position when about 20 seconds passes during this interval after the [
Also, the carriage returns to the standby position when about 20 seconds passes during this interval after the [
] and [
] key is
released.
If the setting could not be made in within the time limit, then do the setting over again from the beginning.
If the setting could not be made in within the time limit, then do the setting over again from the beginning.
- The starting location set by pressing the [BASE POINT] key is released after printing one page.