Printek 4503 User Manual
IBM Proprinter Emulation
Page 4-12
Form Length and Form Feed
Form length is the distance from the top of the form to the bottom of the form. Form
length may be specified either in inches, or in lines. A form feed will advance the
paper to the top of the next form. Some programs do not send form feeds. Instead,
they count line feeds, and send the appropriate number of line feeds to fill out the
page. The usual rational is that the program is then in complete control of form
length, and will work on any printer without requiring the correct form length to be
set. However, the correct form length should always be set on the FormsPro 4000.
Even if the program does not use form feeds, the printer will automatically scroll a
completed form up to the tear bar to be torn off. This automatic scroll is based upon
form length. The easiest way to set form length is via the "Length:" value in the
"Setup: FORM" menu, so it will be correctly set for everyone using the form. If
correct form length cannot be guaranteed from SETUP, then each program should set
the correct form length.
length may be specified either in inches, or in lines. A form feed will advance the
paper to the top of the next form. Some programs do not send form feeds. Instead,
they count line feeds, and send the appropriate number of line feeds to fill out the
page. The usual rational is that the program is then in complete control of form
length, and will work on any printer without requiring the correct form length to be
set. However, the correct form length should always be set on the FormsPro 4000.
Even if the program does not use form feeds, the printer will automatically scroll a
completed form up to the tear bar to be torn off. This automatic scroll is based upon
form length. The easiest way to set form length is via the "Length:" value in the
"Setup: FORM" menu, so it will be correctly set for everyone using the form. If
correct form length cannot be guaranteed from SETUP, then each program should set
the correct form length.
Set Form Length in Lines
ESC C n
Sets the form length to n lines at the current line spacing. 1
≥
n
≥
255. Maximum form
length is 37.9 inches. Invalid form lengths will be ignored. Overrides the "Length:"
value in the "Setup: FORM" menu.
value in the "Setup: FORM" menu.
For example, an 11 inch form contains 66 lines at 6 LPI, but 88 lines at 8 LPI. If line
spacing is changed after setting the form length, the physical form length (in inches)
will not be changed.
spacing is changed after setting the form length, the physical form length (in inches)
will not be changed.
Resets top of form to the current position, so it is wise to be at top of form before
setting form length. Issuing a form feed will guarantee this. Vertical margins are
cleared.
setting form length. Issuing a form feed will guarantee this. Vertical margins are
cleared.
Example: The following escape sequence will set form length to 66 lines. At 6 LPI,
this will result in a form length of 11 inches.
this will result in a form length of 11 inches.
Escape sequence:
ESC
C
66
Hexadecimal:
1B
43
42
Set Form Length in Inches
ESC C NUL n
Sets the form length to n inches. 1
≥
n
≥
37. Maximum form length is 37.9 inches.
Invalid form lengths will be ignored. Overrides the "Length:" value in the "Setup:
FORM" menu.
FORM" menu.
Resets top of form to the current position, so it is wise to be at top of form before
setting form length. Issuing a form feed will guarantee this. Vertical margins are
cleared.
setting form length. Issuing a form feed will guarantee this. Vertical margins are
cleared.