Rimage 110660-001_F Leaflet

110660-001_F 

Copyright © 2009  Rimage Corporation

Page 1

a.  Cut the plastic 

tie wraps (Qty. 2) from 

the lift arm.

n

b.  Remove the 

shipping foam inserted 

above the carousel. 

This document is intended for people who are familiar with hardware setup, software 

installation, and Windows operating systems.
If you do not understand the procedures in this document, ask your computer 

technician for help.
This document describes how to set up your Rimage AutoEverest AutoPrinter. If you 

are using the Everest printer as a standalone printer or with an autoloader, refer to the 

printer or autoloader’s setup and installation instructions.
Documents referenced in this procedure shipped with your product and are also 

available online at 

.

 Select: Printer Series > AutoPrinter > 

User Manuals tab. 

-

•

Read all setup instructions thoroughly before you begin.

•

Save all packing boxes and packing materials for your AutoPrinter and 

Everest printer.

Note: Your product may not look exactly like the product pictured.

#

Required tools: Scissors or side cutters

a.  Unpack the 

Everest printer. 

Refer to the label on the 

Everest printer box.

b.  Follow the instructions on the 

instruction card on the rear 

of the printer.
i.  Set the 

switch.

ii.  Move the 

screw to the storage 

position.

c.  Open the 

Everest printer.

i.  Press the two 

side cover latches.

ii.  Lower the 

side cover.

d.  Open l

atches 1, 2, and 3 as indicated 

by the arrows.

e.  Remove the 

pieces (Qty. 2) from inside the 

printer.

f.  Install the 

print ribbon and 

retransfer ribbon. Refer to 

the instruction label on the side 

cover, or refer to the Everest 

Printer User Guide.