Ricoh Type B User Manual
1394 Interface Unit Type 4510
27
2
JJJJ
Fasten the 1394 Interface Unit to
the controller board.
the controller board.
KKKK
Match the controller board to the
top and bottom rail using the "
top and bottom rail using the "
T
T
T
T"
mark, and then slide it into the
printer slowly until it stops.
printer slowly until it stops.
LLLL
Push back the handle of the con-
troller board until it clicks.
troller board until it clicks.
MMMM
Fasten the controller board to the
printer with the two screws.
printer with the two screws.
Note
❒ If the Duplex Unit is not at-
.
NNNN
While aligning the power cord to
the left side groove of the Duplex
Unit, slide the Duplex Unit in un-
til it is connected to the printer.
the left side groove of the Duplex
Unit, slide the Duplex Unit in un-
til it is connected to the printer.
OOOO
Plug the printer's power cord
back into the wall outlet, and then
turn on the power switch.
You need to make settings with the
control panel before using the 1394
Interface Unit.
back into the wall outlet, and then
turn on the power switch.
You need to make settings with the
control panel before using the 1394
Interface Unit.
ZGDX443J
ZGDX252J
ZGDX380J
ZGDX272J
ZGDX242J