Ricoh Type B User Manual
Installing Options
30
2
GGGG
Place the controller board on a flat
surface.
surface.
HHHH
Use a coin to remove the two
screws, and then remove the cov-
er.
screws, and then remove the cov-
er.
Note
❒ These screws are used again in
step
.
IIII
Attach the 802.11b Interface Unit.
Insert the end of the 802.11b Inter-
face Unit into the opening (
Insert the end of the 802.11b Inter-
face Unit into the opening (
A), and
then push down until it clicks (
B).
JJJJ
Fasten the 802.11b Interface Unit
to the controller board with the
two screws.
to the controller board with the
two screws.
KKKK
Insert the card slowly into the
802.11b board with the label fac-
ing down and the uneven black
antenna surface facing up until it
stops.
802.11b board with the label fac-
ing down and the uneven black
antenna surface facing up until it
stops.
LLLL
Match the controller board to the
top and bottom rail using the "
top and bottom rail using the "
T
T
T
T"
mark, and then slide it into the
printer slowly until it stops.
printer slowly until it stops.
ZGDX410J
ZGDX420J
ZGDX431J
ZGDX442J
ZGDX500J
ZGDX251J