Pelco cm6800-322x6 User Manual

C1522M-C (2/05)

11

Unpack and inspect all parts carefully. The following parts are supplied:

1

CM6800 Switcher/Controller

4

10-32 x .750-inch pan head screws

4

.500” OD nylon washers

1

Power cord

2

6-foot (1.8 m) straight data cables with RJ-45 connectors

1

6-foot (1.8 m) reversed data cable with RJ-45 connectors

2

RJ-45 wall block terminals

NOTE:  There are no user-serviceable parts inside this unit. Only authorized service personnel may open the unit.

1.

Select a suitable location for the CM6800. It occupies 5.25 inches (13.34 cm) of vertical space, or three rack units (RUs), in a
universal mount. The CM6800 must be within 6 feet (1.8 m) of a suitable electrical outlet.

2.

The CM6800 is shipped with the rack ears installed at the front. Reposition as needed for your application. If the ears are not
required, remove them.

Figure 2.  Installing Rack Ears

3.

Use supplied pan head screws and washers to mount the CM6800 in a standard 19-inch (48.26 cm) equipment rack or wood or sheet
metal screws to mount against a flat surface, according to your installation requirements.

Figure 3.  Mounting the CM6800 Matrix Switcher/Controller

POSITION BRACKETS FOR
RACK MOUNTING (FRONT)

POSITION BRACKETS FOR
FLUSH MOUNTING
(WALL AND TABLE TOP)

POSITION BRACKETS FOR
RACK MOUNTING (REAR)

NOTE: EACH CM6800 COMES
WITH 2 RACK EARS

POSITION BRACKETS FOR
UNDER-TABLE MOUNTING

00624

00615