Lexmark X925de User Manual

Page of 335
Universal Setup menu
Menu item
Description
Units of Measure
Inches
Millimeters
Identifies the unit of measure
Note: Inches is the US factory default setting. Millimeters is the
international factory default setting.
Portrait Width
3–48 inches
76–1219 mm
Sets the portrait width
Notes:
11.69 inches is the US factory default setting. Inches can be
increased in 0.01
‑inch increments.
296.9 mm is the international factory default setting. Millimeters
can be increased in 1
‑mm increments.
If the width exceeds the maximum, then the printer uses the
maximum width allowed.
Portrait Height
3–48 inches
76–1219 mm
Sets the portrait height
Notes:
48 inches is the US factory default setting. Inches can be increased in
0.01
‑inch increments.
1219 mm is the international factory default setting. Millimeters can
be increased in 1
‑mm increments.
If the height exceeds the maximum, then the printer uses the
maximum height allowed.
Feed Direction
Short Edge
Long Edge
Specifies the feed direction
Notes:
Short Edge is the factory default setting.
Long Edge appears only if the longest edge is shorter than the
maximum width supported by the tray.
Reports menu
Reports menu
Menu item
Description
Menu Settings Page
Prints a report containing information about the paper loaded into trays, installed
memory, total page count, alarms, timeouts, printer control panel language,
TCP/IP address, status of supplies, status of the network connection, and other
information
Device Statistics
Prints a report containing printer statistics such as supply information and details
about printed pages
Understanding printer menus
158