OKI 410dn User Manual

Paper recommendations > 33

Envelopes should be loaded flap down, face up with the top edge to the left and

short edge into the printer.

Load Transparencies face up and top edge into the printer.

For heavyweight paper or cardstock open the rear output cover to collect the

printed output. This will give the paper a nearly straight path through the

machine, avoiding paper jams and damage to the paper.

B420, B430: If required, set the media size and orientation in the media menu

using the control panel, then issue the print command.
B410: If required, set the media size and orientation in the Printer Menu Setup tool,

then issue the print command.

APER

FEED

SIZE

AND

MEDIA

SETTING

The process used to fuse (fix) the printed image to the paper involves a mixture of pressure

and heat. Too much heat will cause lightweight paper to crease or curl and corrugations in

transparencies. Too little heat will cause the image not to fuse fully into heavyweight paper.

B410

AND

B410

You can change

the media type as follows:

Start the Printer Menu Setup tool.

Click Media Menu.

Click on the paper tray being used. Adjust the media type to the required setting

and, if necessary, the paper size to the size of the paper being used.

Click on the Setup tab and click Apply the changed settings, then OK to set the

printer to the new media type.

NOTE
Do not select Duplex printing on envelopes.

CAUTION!

Damage to the printer may occur if the incorrect paper setting is

used when printing on a different media.

NOTE

You can also set the media type in your printer driver. However, the
printer driver settings will override the settings on the control panel or
Printer Menu Setup Tool.

Remember to reset the printer for normal paper after printing on a
different media.

NOTE
Although media properties can be set in the printer driver for particular jobs,
when filling a tray with media it is recommended that you manually set the
printer to match the media as described here.