Mustek PP7000 User Manual

 

moment, a font table will be printed in text mode again. To exit 
the test printing, please turn the printer off and on again.

 

The near end sensor for paper 

roll in the printer is now able to 
have the printer work with paper 
rolls of several bobbin sizes. Please 
refer to the picture at right from 
inside the paper roll compartment 
that there are a fixing screw and a 
sensor head in the wall. Slightly 
release the fixing screw to adjust the position of sensor head. The 
acceptable paper roll bobbin outer diameter is between 18 and 
22mm. This adjustment allows sensor activation on paper roll 
overall diameter between 21 and 23.6 mm unless for too light 
bobbins. Remember, for smaller roll diameter, the sensor head 
should go higher. 

Sensor Head 

Fixing Screw 

When the paper 

roll to put (back) in is 
already nearly used up, 
the paper roll must be 
placed in the way that 
the paper roll touches 
the sensor head from 
the outer surface but never allow the sensor head to ride on the 
bobbin body between the inner and outer diameter of the paper 
roll bobbin nor to go into the inner diameter of the paper roll 
bobbin. It is also noticed that some market available paper roll has 

Bobbin I.D. 

Bobbin O.D. 

Thermal 
Paper 
Surface

 

2 - 5