Olivetti 200MF User Manual

The table below provides general guidelines for problem solving. 

If a problem occurs with your machine, carry out the checkpoints and 
procedures indicated on the following pages. If the problem persists, 
contact your Service Representative or Authorized Service Center.

Nothing lights on the 
operation panel when 
the power switch is 
turned on.

Is the power plug 
connected to an AC 
outlet?

Connect the plug to an AC outlet.

No copies come out 
when [Start] is pressed.

Is there some indication 
of the trouble on the 
operation panel?

Check the appropriate response to that 
indication and perform the 
corresponding procedure.

The copies are blank.

Were the originals set 
correctly?

When setting originals on the Platen, set 
them face-down.

When setting originals in the optional 
Document Processor, set them face-up.

The copies come out too 
light.

Is the copier in Auto 
Exposure Adjustment 
mode?

In order to adjust the overall exposure 
level, perform the Auto Exposure 
Adjustment procedure.

Is the manual exposure 
mode set?

Use the Image Quality key to adjust the 
exposure level properly.

To adjust the overall exposure, perform 
the relevant exposure adjustment 
procedure in each image quality mode.

Is the toner evenly 
distributed in the toner 
container?

Shake the toner container horizontally 
approximately 10 times.

Is the copier in EcoPrint 
mode?

Select an image quality mode other than 
the EcoPrint mode.

Is Add Toner displayed? Replace the Toner Container.

Is the copy paper wet?

Replace the copy paper with new paper.

Is the electrical charge 
section dirty?

Open the front cover and use the 
charger cleaner rod to clean the 
electrical charge section.